Hoover FH40190 Product Manual - Page 14
Cleaning the Nozzle and SpinScrub - parts
View all Hoover FH40190 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Keeping your FloorMate® Edge running properly: Cleaning the Nozzle and SpinScrub®: IMPORTANT: The tanks should be emptied and cleaned after each use and before storage. ! CAUTION ! To reduce risk of injury from moving parts - Unplug before servicing. Lubrication: The motor is equipped with bearings which contain sufficient lubrication for their lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor. Any other servicing should be 1 done by an authorized service representative. If appliance Nozzle can be removed for easy cleaning. Slide is not working as it should, the two nozzle release has been dropped, damaged, latches outwards. left outdoors, or dropped into water, take it to a service center prior to continuing use. 11 2 Remove nozzle by tilting downward then pulling straight out. Rinse under running water to clean. 3 Pull SpinScrub® block out. The brushes can be rinsed under water to remove debris (Max 100°F). To replace the SpinScrub® block, press firmly and lock into place. Then replace nozzle by sliding the two latches inward, locking the nozzle in place.