Hoover S2200 Manual - Page 5
Final filter, Rug and floor, nozzle, Lubrication - replacement parts
UPC - 073502025178
View all Hoover S2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
3-4 3-5 3-6 C Pull filter (C) inside out through filter frame. Brush the surface of filter to remove any clinging litter. (Filter may be washed in warm water. It must be completely dry before replacing in cleaner. Do not use cleaner without filter in place.) Push filter back through frame. 3-7 3-8 Place filter on top of cup as shown and push firmly into cup. E Place bottom of cup (E) first, then pivot cup into position. Press top of cup to snap it into place. NOTE: Filter must be in place for cup to latch. 3-9 G F Final filter How to replace The final filter assists in returning clean air to the room. The filter is located on the side of the cleaner body. When it becomes dirty, it must be replaced. Replace with part no. 59136-022. Disconnect cleaner from electrical outlet. To replace, press down on grill tab (F) and remove grill. Remove the felt filter (G) and replace with a new one. 3-10 H I To replace the filter grill, insert tabs (H) at the bottom of the grill into slots (I) in the cleaner body. Press on grill to snap it into position. Rug and floor nozzle To maintain the cleaning effectiveness of your rug and floor nozzle, the brushes may need to be replaced occasionally. See your nearest Hoover Factory Service Center or Authorized Warranty Dealer (Depot) for new brushes. Lubrication The motor is equipped with two bearings. These bearings contain sufficient lubrication for the life of the motor. Therefore, do not add lubricant to either motor bearing. Continued 5