Hoover S2200 Manual - Page 6

If you have a, problem - international

Page 6 highlights

Thermal protector An internal thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector activates, the motor will stop running. If this happens, proceed as follows: 1. Turn the switch off and unplug the unit from electrical outlet. Allow the unit to cool for 30 minutes before restarting. 2. Empty the dirt cup and clean the filter (see "Dirt cup" section). 3. Check final filter for dirt accumulation. 4. When the motor cools, the thermal protector automatically resets and cleaning may continue. If the thermal protector continues to activate, your cleaner may need servicing (see "Service" section). 4. If you have a problem If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below. Problem: Cleaner won't run Possible cause Possible solution • Not firmly plugged in. • Plug unit in firmly. • No voltage in wall receptacle. • Check fuse or breaker. • Blown fuse/tripped breaker. • Replace fuse/reset breaker. • Thermal protector activated. • Unplug cleaner and allow it to cool (this will reset the thermal protector) (see "Thermal protector") Problem: Cleaner suction low Possible cause Possible solution • Dirt cup full. • Empty dirt cup. • Filter clogged. • Empty dirt cup and clean filter. • Nozzle clogged. • Remove obstruction. Problem: Cleaner is difficult to push on carpet Possible cause Possible solution • Nozzle set for BARE FLOOR • Set nozzle for RUG. Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under "Vacuum Cleaners Household" OR - • checking the list of Factory Service Centers provided with this cleaner OR - • checking the Service section of The Hoover Company on-line at www.hoover.com OR - • calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only). Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay. If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone: 1-330-499-9499. In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone: 1-800-263-6376. Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears in the middle of the back of the cleaner body.) Full One Year Warranty (Domestic Use) Your HOOVER® appliance is warranted in normal household use, in accordance with the Owner's Manual against original defects in material and workmanship for a period of one full year from date of purchase. This warranty provides, at no cost to you, all labor and parts to place this appliance in correct operating condition during the warranted period. This warranty applies when the appliance is purchased in the United States including its territories and possessions, or in Canada or from a U. S. Military Exchange. Appliances purchased elsewhere are covered by a limited one year warranty which covers the cost of parts only. This warranty does not apply if the appliance is used in a commercial or rental application. Warranty service can only be obtained by presenting the appliance to one of the following authorized warranty service outlets. Proof of purchase will be required before service is rendered. 1. Hoover Factory Service Centers. 2. Hoover Authorized Warranty Service Dealers (Depots). For an automated referral of authorized service outlets in the U.S.A., phone 1-800-944-9200 OR Visit The Hoover Company on-line at www.hoover.com This warranty does not cover pick up, delivery, or house calls; however, if you mail your appliance to a Hoover Factory Service Center for warranty service, transportation will be paid one way. While this warranty gives you specific legal rights, you may also have other rights which vary from state to state. If further assistance is needed, or if there are questions concerning this warranty or the availability of warranty service outlets, write or phone the Consumer Response Center, The Hoover Company, 101 East Maple St., North Canton, Ohio 44720. Phone 1-330-499-9499. In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, 1-800-263-6376. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7

6
Service
T
o obtain approved HOOVER service and
genuine HOOVER parts, locate the near-
est
Hoover Factory Service Center or
Authorized Hoover Warranty Service
Dealer (Depot)
by:
checking the Yellow Pages
under “Vacuum Cleaners -
Household” OR -
• checking the list of Factory
Service Centers provided
with this cleaner OR -
• checking the Service section of The
Hoover Company on-line at
www.hoover.com
OR -
• calling
1-800-944-9200
for an
automated referral of
authorized service outlet
locations (U.S. only).
Do not
send your cleaner to The Hoover
Company in North Canton for service, this
will only result in delay.
If further assistance is needed, contact
The Hoover Company Consumer
Response Center, North Canton, Ohio
44720
Phone:
1-330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone:
1-800-263-6376.
Always identify your cleaner by the
com-
plete
model number when requesting
information or ordering parts.
(The model
number appears in the middle of the back
of the cleaner body.)
Problem:
Cleaner suction low
Possible cause
Possible solution
• Dirt cup full.
Empty dirt cup.
• Filter clogged.
Empty dirt cup and clean filter.
• Nozzle clogged.
Remove obstruction.
Problem:
Cleaner is difficult to push
on carpet
Possible cause
Possible solution
• Nozzle set for BARE FLOOR
Set nozzle for RUG.
Full One Year
Warranty
(Domestic Use)
Your HOOVER® appliance is warranted in
normal household use, in accordance with
the Owner’s Manual against original
defects in material and workmanship for a
period of one full year from date of pur-
chase.
This warranty provides, at no cost
to you, all labor and parts to place this
appliance in correct operating condition
during the warranted period.
This warran-
ty applies when the appliance is pur-
chased in the United States including its
territories and possessions, or in Canada
or from a U. S. Military Exchange.
Appli-
ances purchased elsewhere are covered
by a limited one year warranty which cov-
ers the cost of parts only.
This warranty
does not apply if the appliance is used in
a commercial or rental application.
Warranty service can only be obtained by
presenting the appliance to one of the fol-
lowing authorized warranty service out-
lets.
Proof of purchase will be required
before service is rendered.
1.
Hoover Factory Service Centers.
2.
Hoover Authorized Warranty Service
Dealers (Depots).
For an automated referral of authorized
service outlets in the U.S.A.,
phone 1-800-944-9200
OR
Visit The Hoover Company on-line at
www.hoover.com
This warranty does not cover pick up,
delivery, or house calls; however, if you
mail your appliance to a Hoover Factory
Service Center for warranty service, trans-
portation will be paid one way.
While this warranty gives you specific
legal rights, you may also have other
rights which vary from state to state.
If further assistance is needed, or if there
are questions concerning this warranty or
the availability of warranty service outlets,
write or phone the Consumer Response
Center, The Hoover Company, 101 East
Maple St., North Canton, Ohio 44720.
Phone 1-330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
1-800-263-6376.
4. If you have a
problem
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list below.
Problem:
Cleaner won’t run
Possible cause
Possible solution
• Not firmly plugged in.
Plug unit in firmly.
• No voltage in wall receptacle.
Check fuse or breaker.
• Blown fuse/tripped breaker.
Replace fuse/reset breaker.
• Thermal protector activated.
Unplug cleaner and allow it to cool (this
will reset the thermal protector) (see “Ther-
mal protector”)
Thermal protector
An internal thermal protector has
been designed into your cleaner to
protect it from overheating.
When the thermal protector acti-
vates, the motor will stop running.
If this happens, proceed as follows:
1.
Turn the switch off and unplug
the unit from electrical outlet.
Allow
the unit to cool for 30 minutes before
restarting.
2. Empty the dirt cup and clean the
filter (see “Dirt cup” section).
3. Check final filter for dirt accumu-
lation.
4.
When the motor cools,
the ther-
mal protector automatically resets and
cleaning may continue.
If the thermal protector continues to
activate, your cleaner may need ser-
vicing (see “Service” section).