Hoover Steam Mop Product Manual English - Page 2

GETTING STARTED WITH YOUR STEAM CLEANER CARTON CONTENTS IMPORTANT: When using on carpets, always ensure the multi-surface Microfiber Pad is properly attached to the Floor Head. A B C* D E F A. Handle B. Steam Cleaner Body C. Microfiber Pads *quantities vary per model D. Carpet Glider** E. Fill Cup F. Water Filter (Pre-assembled in steam cleaner) **Select models only ASSEMBLY 1. Place the cleaning pad on the floor white side facing up. Place steam cleaner on top of pad making sure the Floor Head covers the entire pad. Hook and loop feature on the bottom of the mop will hold the pad in place. HOW TO USE 1. Handle 2. Quick Release Cord 3. Water Tank Cap 4. Water Tank 5. Steam Control Dial 6. Steam Ready Light 7. Hard Water Filter (rear) 8. Floorhead 9. Carpet Glider 5. Plug into an outlet. Turn steam control dial clockwise to turn on. The steam ready light will illuminate with a red light upon start. 6. Steam control light will maintain a solid red to indicate the machine is on and heating up. 7. Adjust the Steam Control Dial between Min and Max Steam to control the amount of steam. MIN for light steaming, MAX for the most amount of steam. 8. Green light will illuminate to show the Steam Mop is ready to use. 1. Place the microfiber pad on the floor white side facing up. Place floor head onto pad making sure the entire pad covers the floor head. 2. With microfiber pad attached, hook the steam cleaner into the front of the carpet glider and push to clip into place. Carpet glider should only be used when refreshing carpets. 9. To recline the steam cleaner place foot here and pull handle backwards. 1. Insert the body into the floor head until it clicks into place. 2. Insert the handle until it clicks into place. ATTACH MICROFIBER PAD WARNING: To reduce the risk of personal injury - Unplug the steam cleaner when assembling the accessories. IMPORTANT: Never use the Steam Cleaner without the Microfiber Pad correctly attached to the Floor Head. The "Multi-Surface Microfiber Pad" can be used on all sealed hard floor surfaces as well as carpet. When using on carpet the carpet glider attachment should be utilized as directed in the "Refreshing Carpet" section of this manual. 1. Remove Water Tank Cap by turning counterclockwise from the lock to unlocked position. 2. Use the provided fill cup to fill machine with distilled water. 3. Two fill cups worth of water will be needed to fill the entire tank. 4. Replace the Water Tank Cap back on the machine and turn clockwise from unlocked to locked position 10. Move the steam cleaner slowly backwards and forwards across the floor. REFRESHING CARPETS WARNING: To reduce the risk of personal injury - Unplug the steam cleaner when assembling the accessories. WARNING: Do not clean over floor electrical outlets. Do not use steam cleaner without water in the Main Water Tank. 3. Turn Steam Control Dial clockwise to turn on. 4. To recline the steam cleaner place foot here and pull handle backwards. 5. Move the steam cleaner slowly backwards and forwards across the carpet.