Hoover UH50000 Manual - Page 14
V-belt, Brushroll - belts
UPC - 073502029695
View all Hoover UH50000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
V-belt ! WARNING ! Agitator brushroll can start suddenly. Unplug cleaner before turning it over. How to Inspect The V-belt is designed to last for a long time and is not normally replaced. However, if V-belt is cracked, gouged or broken, now is a good time to replace it as follows. Slide flat belt off large pulley as shown in Fig. 3.10. How to Remove 3.14 To remove V-belt, slide back of belt over pulley (C). Then firmly pull on belt and "snap" it out. Discard used belt and replace. To install new belt (with lettering on outside of belt), slide back of belt over pulley and pull front of belt toward groove (E) next to pulley. Belt will "pop" into place. Positioning Belt on Brushroll Before positioning belt onto brushroll, check for debris accumulation as described in Fig. 3.23. 3.15 Insert brushroll through belt and position belt in groove (F) on brushroll. 3.14 E C 3.15 F What to Buy: V-Belt When purchasing a new V-Belt, ask for HOOVER® part No. 38528034. If desired, additional belts can be purchased at Hoover.com or 1-800-944-9200. Brushroll ! WARNING ! Agitator brushroll can start suddenly. Unplug cleaner before turning it over. 3.16 3.17 When to Replace Unplug cleaner when it is turned over. When brushroll brushes are worn, it should be replaced. 3.16 To check condition of brushes, move the edge of a card across bottom plate while turning brushroll. To maintain cleaning effectiveness, replace brushroll if brushes do not touch card. How to Remove 3.17 Slide Brushroll Control (Fig. 2.9) to "Hard" (OFF) position. Turn cleaner over and remove bottom plate (Fig. 3.9). Lift up brushroll and slide V-belt (D) off brushroll. How to Install 3.18 Grasp brushroll and fit it into position by first sliding end, opposite the belt, into the rectangular slot (G) on side of cleaner. Push other side of brushroll (H) into place. Belt may fit loosely when properly installed. Reposition flat belt and bottom plate (Fig. 3.13) D 3.18 G H What to Buy: Brushroll When purchasing a new brushroll, ask for HOOVER® part No. 48414144. If desired, additional brushroll can be purchased at Hoover.com or 1-800-944-9200. Actual model may vary from images shown. 14