Hoover UH50000 Manual - Page 17
Troubleshooting
UPC - 073502029695
View all Hoover UH50000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
4. TROUBLESHOOTING If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below. Any other servicing should be done by an authorized service representative. ! WARNING ! To reduce risk of personal injury - unplug cleaner before servicing. PROBLEM POSSIBLE CAUSE Cleaner won't run Not firmly plugged in. POSSIBLE SOLUTION Plug unit in firmly. No voltage in wall plug. Blown fuse or tripped breaker. Thermal protector activated. Check fuse or breaker. Replace fuse or reset breaker. Allow cleaner to cool for 30 minutes (this will reset the thermal protector). Agitator brushes Custom Control™ switch set Set switch to carpet position. aren't turning on bare floor position. Agitator is obstructed. Clear obstruction. Cleaner / tools won't pick up Broken or worn belt. Brushroll worn. Filter bag full. Replace belt. Replace brushroll. Change filter bag. Incorrect carpet height setting. Move carpet height control to lower setting. Blockage in air flow passage. Clear blockage. Cleaner hard to Incorrect carpet height setting. Move carpet height control to higher setting. push Cleaner won't self-propel Brushroll not turning Flat belt broken or worn. Self-propel button in OFF position. Brushroll in OFF position. Replace belt. Slide button to ON. Move brushroll control to ON position (carpet). Powered hand tool brushroll won't turn Flat belt broken or worn Too much pressure being applied to tool. Blockage in turbine channel. Replace belt Continue using tool applying light pressure. Remove blockage. Broken or worn belt. Replace belt Low cleaner suction. Check items under "Cleaner won't pick up". 17