Hoover WindTunnel Max Capacity Upright Vacuum Product Manual - Page 11

BRUSHROLL: How to Clean ! CAUTION ! To reduce the risk of injury from moving parts - Unplug before servicing. Brushroll - Bottom plate with screws Place handle in the low position and turn the cleaner over so the bottom side is up. 4.17 Remove the 6 screws as shown with a Phillips screwdriver. 4.18 Pivot off bottom plate. 4.19 Remove any debris and/or hair from brushroll. Replace the bottom plate aligning the screw holes and install the 6 screws as shown. 4.17 4.19 4.18 BELT ! CAUTION ! 4.20 4.21 To reduce the risk of injury from moving parts - Unplug before servicing. The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition. When To Replace Replace belt if it is damaged, cut or broken. Refer to directions below. 4.22 4.23 D How To Replace - Bottom plate with screws Place handle in the low position and turn the cleaner over so C the bottom side is up. 4.20 Remove the 6 screws as shown with a Phillips screwdriver. 4.21 Lift off bottom plate (A). 4.22 Remove used belt from brushroll (C) then from motor shaft (metal rod) (D) and discard. 4.23 With lettering on outside of belt, slide new belt over motor shaft (metal rod) (E). Then slip around area of brushroll without bristles (G). 4.24 D 4.24 With belt in place, pull and slide brushroll into nozzle making sure that the brushroll end caps are in the correct orientation. G Place the bottom plate aligning the screw holes and re-install the 6 screws. What to Buy: Belt If desired, additional belts can be purchased at Hoover.com or 1-800-944-9200. When purchasing a new belt for models ask for Belt - HOOVER® part No. 562932001. 11 Actual model may vary from images shown.