Hunter 36316 Owner's Manual - Page 5

2 Using Your Humidifier Initial Setup and Operation 1. Remove the Hunter® Evaporative Humidifier from its packaging. 2. Use the housing handle to carry the unit to where it will be run. 3. Place the humidifier on a hard, flat, water resistant surface. Always place the humidifier at least six (6) inches away from walls and sources of heat. 4. Remove the tank by pulling the tank handle away from the unit until the clip at the top releases, then pull the tank upward and out. Figure 1. 5. Turn the tank upside down and remove the tank cap by turning counterclockwise. Figure 2. 6. Fill the tank with clean, cool tap water and replace the tank cap by turning it clockwise until tight. Caution: Never fill the humidifier with hot water. 7. Turn the tank upright and place it back into the Base at an angle and then push the tank handle towards the base until the tank clip snaps into place. Figure 3. 8. Plug the unit into a wall outlet and start the humdifier. See "Controls" on page 6. Figure 1. Figure 2. Clip ©2011 Hunter Fan Company Figure 3. 5