Husqvarna 336FR Owners Manual - Page 16
Adjusting the harness and brush, cutter, Standard harness
View all Husqvarna 336FR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ASSEMBLY Place the locking pin in the groove on the screw head Standard harness and tighten. See diagram. L M C A • Fit the drive disc (B) on the output shaft. H Quick release At the front is an easily accessible, quick release. Use this if the engine catches fire or in any other emergency situation that requires you to free yourself from the machine and harness. B A C ML • Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. • Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation. H H Spreading the load on your shoulders A well-adjusted harness and machine makes work much easier. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders. • To dismantle, follow the instructions in the reverse order. Adjusting the harness and brush cutter WARNING! When using a brush cutter it ! must always be hooked securely to the harness. Otherwise you will be unable to control the brush cutter safely and this can result in injury to yourself or others. Never use a harness with a defective quick release. Correct height 1 Forestry clearing The machine should be supported in a harness when forestry clearing so that the cutting equipment is angled slightly forwards in relation to the ground. Adjust the height using the strap on the harness for the support hook. 16 - English