Husqvarna 525RX Operation Manual - Page 13
Assembling the cutting, equipment, Fitting a blade guard, grass blade, and grass cutter
View all Husqvarna 525RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ASSEMBLY Dismantling • Loosen the coupling by turning the knob (at least 3 times). Fitting a blade guard, grass blade and grass cutter • Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling. G F E D A B C C Assembling the cutting equipment WARNING! ! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. • Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt. CAUTION! Use the recommended blade guard. See the Technical data section. • Fit the drive disc (B) on the output shaft. • Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. • Place the blade (D), support cup (E) and support flange (F) on the output shaft. • Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread). WARNING! Never use a cutting ! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness. English - 13