Husqvarna HU725AWDEX Operation Manual - Page 6
To Install Attachments, Install Starter Rope See Fig. 3, To Prepare Battery See Fig. 4
View all Husqvarna HU725AWDEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY INSTALL STARTER ROPE (See Fig. 3) 1. Loosen T-knob. 2. Hold control bar against upper handle. 3. Slowly pull engine starter rope out until rope will slip into loop of rope guide. 4. Tighten T-knob. TO PREPARE BATTERY (See Fig. 4) NOTE: Your battery must be charged before you can start your lawn mower. 1. Open port on electric start housing. 2. Connect battery charger connector (male) to battery connector (female). 3. Plug battery charger into 110 volt A.C. outlet. • Leave battery charger connected for 24 hours before starting your engine for the first time. Connect your battery charger to charge battery as required. IMPORTANT: THE ENGINE WILL NOT RECHARGE YOUR BATTERY. At the end of the mowing season the battery should be charged for 48 hours to protect the battery during winter storage. CONTROL BAR UPPER HANDLE ELECTRIC START HOUSING ROPE GUIDE T-KNOB ENGINE STARTER ROPE FIG. 3 BATTERY CHARGER FIG. 4 TO INSTALL ATTACHMENTS Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see "TO CONVERT MOWER" in the Operation section of this manual. 6