Husqvarna HU775BBC Owners Manual - Page 7
To Adjust Cutting Height See Fig. 8, Drive Control Adjustment See Fig. 7, Drive Control See Fig. 6 - mowers
View all Husqvarna HU775BBC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
OPERATION DRIVE CONTROL (See Fig. 6) • Self-propelling is controlled by pulling either drive control lever rearward to the handle. The further toward the handle a lever is pulled, the faster the unit will travel. • To stop forward motion without stopping blade, release a drive control lever. NOTE: If after releasing the drive control the mower will not roll backwards, push the mower forward slightly to disengage drive wheels. DRIVE CONTROL ADJUSTMENT (See Fig. 7) Over time, the drive control system may become "loose", resulting in decreased speed. There is a turnbuckle on the drive control housing to increase tension on the drive cable. Proceed as follows: 1. Turn unit off and disconnect spark plug wire from spark plug. 2. Rotate turnbuckle on drive control to increase drive speed. 3. Operate mower to test drive speed. Readjust as required. 4. If condition fails to improve after the above steps (forward speed remains the same), your drive belt is worn and should be replaced. OPERATOR PRESENCE CONTROL BAR TO ENGAGE DRIVE CONTROL DRIVE CONTROL LEVERS DRIVE CONTROL DISENGAGED FIG. 6 ADJUSTMENT TURNBUCKLE FIG. 7 TO ADJUST CUTTING HEIGHT (See Fig. 8) All four wheels are adjusted by a single lever. • Pull adjuster lever toward wheel. To raise mower, move lever forward to desired position. To lower mower, move the lever toward the rear. WHEEL ADJUSTER LEVER LEVER BACKWARD TO LOWER MOWER LEVER FORWARD TO RAISE MOWER 7 FIG. 8