Husqvarna LE475 Owners Manual

Husqvarna LE475 Manual

Get Husqvarna LE475 PDF manuals and user guides View all Husqvarna LE475 manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna LE475 manual content summary:

  • Husqvarna LE475 | Owners Manual - Page 1
    OPERATOR'S MANUAL / 2008 WITH PARTS LIST EDGER/TRIMMER Model: LE475 / 966951101 • Speci cations • Operating Instructions • Maintenance Information
  • Husqvarna LE475 | Owners Manual - Page 2
    8 Maintaining Your Edger-Trimmer 9 Maintenance Check List 9 Engine 9 Oil Quality 9 Oil Level 9 Oil Changes 9 Spark Plug 9 Blade Maintenance 9 Blade Changes 9 Lubrication 9 Storage Instructions 13 Maintenance Notes 13-15 Parts Illustration 10 Parts List 11 Troubleshooting Chart 12
  • Husqvarna LE475 | Owners Manual - Page 3
    1. Read the Operating and Maintenance Instruction Manual carefully. Be thoroughly 8. If edger-trimmer should start to vibrate abnormally, stop the engine and check for the cause. familiar with the controls and proper use of Vibration is generally a warning of trouble. the equipment. 9. Stop the
  • Husqvarna LE475 | Owners Manual - Page 4
    EDGER-TRIMMER FEATURES Throttle Lever Clutch & Depth Lever Control Rod Gasoline Fill Recoil Starter Air Cleaner Engine Blade Guard Belt Guards Oil Fill Front & Back Cutterhead Blade 4
  • Husqvarna LE475 | Owners Manual - Page 5
    operator's position of the handle, facing forward. The lawn edger, except the handle and throttle control, is fully assembled, packed, and shipped in one container. ATTACHING THE HANDLE 1. Remove handle brace, nuts, and bolts. Align the handle, lower support, and handle brace holes. Use all six nuts
  • Husqvarna LE475 | Owners Manual - Page 6
    position before starting engine. Manually pull out choke on belt and blade. Notches in base of lever permit adjusting depth of cut for edging and height for trimming. TO STOP Disengage edger-trimmer clutch and depth lever. Move throttle control to stop position. Make sure engine is stopped and blade
  • Husqvarna LE475 | Owners Manual - Page 7
    cutterhead are positioned so the blade will not strike the wheels. Wheel Spacer Positioned For Trimming Fig. 4 CURB RIDING POSITION Remove the spacer from between the front wheels. Slide the right wheel toward the left wheel and replace the spacer between the wheel and right frame. Only vertical
  • Husqvarna LE475 | Owners Manual - Page 8
    together at right side of trimmer-edger. Before starting engine, remove wheel spacer clip on front axle, slide wheels to side away from blade, and replace spacer. After starting engine, set blade depth and by slightly lifting rear wheels, guide edger-trimmer around corners and odd angles. WARNING
  • Husqvarna LE475 | Owners Manual - Page 9
    the electrode air gap as indicated in the engine manual. BLADE MAINTENANCE MAINTENANCE CHECKLIST 1. Refer to the engine manual for engine maintenance instructions. 2. Correct grade of oil and gasoline is included in the instructions. Check the oil level of the engine every time the edger-trimmer is
  • Husqvarna LE475 | Owners Manual - Page 10
    LAWN EDGER AND TRIMMER PARTS ILLUSTRATION 10
  • Husqvarna LE475 | Owners Manual - Page 11
    LAWN EDGER AND TRIMMER PARTS LIST REF. PART Front Wheel Spacer (2-13/16" Use With 7075-7 Wheels) wheels Engine Pulley REF. PART NO. NO. 34 Blade Guard Bolt 1/4-28 x 1-1/2 Hex (2 Req.) Blade Guard Main Complete Blade Belt (4L-300) Cutting Blade 1-1/4 Pin U-Clamp Spacer Grease Fitting Handle and Wheel
  • Husqvarna LE475 | Owners Manual - Page 12
    TROUBLESHOOTING Dirty air cleaner.* 3. Operation erratic. A. Dirt in gas tank. Drain, clean and re ll. B. Dirty air cleaner.* B. Carburetor improperly adjusted.* C. Dirty air cleaner.* 5. Idles poorly. A. carburetor.* B. Remove any obstructions from air passages in shrouds. C. Clean cooling
  • Husqvarna LE475 | Owners Manual - Page 13
    STORAGE INSTRUCTIONS Edger-trimmers stored for any length of time should be completely drained of fuel to prevent gum deposits forming on essential parts such as the rope on the engine to spread the oil. Replace spark plug. 5. Clean dirt and cha from cylinder and cylinder head ns, blower housing,
  • Husqvarna LE475 | Owners Manual - Page 14
    MAINTENANCE NOTES 14
  • Husqvarna LE475 | Owners Manual - Page 15
    MAINTENANCE NOTES 15
  • Husqvarna LE475 | Owners Manual - Page 16
    commercial/professional use (parts and labor).Saw must be operated with Husqvarna XP 2 cycle oil. 90 Day Commercial to, belts, blades, blade adapters, bulbs, clutches, clutch drums, filters, guide bars, the Owner's/Operator's manual or instruction sheet furnished by Husqvarna; (3) Alterations or
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
OPERATOR'S
MANUAL
/ 2008
WITH PARTS LIST
EDGER/TRIMMER
•
Specifications
•
Operating
Instructions
•
Maintenance
Information
Model:
LE475
/ 966951101