Husqvarna LE475 Owners Manual - Page 7
Operating Your Edger-trimmer, Cont., Curb Riding Position, Wheel Positioning See Fig. 4, Notes - wheeled edger
View all Husqvarna LE475 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
OPERATING YOUR EDGER-TRIMMER, CONT. WHEEL POSITIONING (See Fig. 4) The wheel adjusting spacer should be centered between the wheels when edging in the vertical position. Wheels must be in the dual position to the right when edging with cutterhead in an angle position or trimming (horizontal position). WARNING Do not change wheel positions when engine is running. Remove the spacer from between the wheels by lifting on spacer with open side down. Slide the left front wheel on the axle toward the right wheel, and once again install the spacer on the axle between the frame and wheel. CAUTION Before starting the engine, be sure the wheels and cutterhead are positioned so the blade will not strike the wheels. Wheel Spacer Positioned For Trimming Fig. 4 CURB RIDING POSITION Remove the spacer from between the front wheels. Slide the right wheel toward the left wheel and replace the spacer between the wheel and right frame. Only vertical edging can be done in this position. NOTE: As pictured above, wheels are positioned to the right for trimming. The wheels are positioned to the left for curb riding edging. NOTES 7