Husqvarna YT48CS Operation Manual - Page 20

SERVICE AND ADJUSTMENTS 2. ASSEMBLE FRONT GAUGE WHEEL (W) TO FRONT OF MOWER (See Fig. 30) HW X ZY H. FRONT MOWER BRACKET W. FRONT GAUGE WHEEL X. SHOULDER BOLT Y. 1-1/4 O.D. WASHER Z. 3/8-16 LOCKNUT Fig. 30 3. TURN STEERING WHEEL LEFT AND POSITION MOWER (See Fig. 31) • Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield (Q) to the right. FRONT Q ENGINE 5. INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED) (See Fig. 33 - 35) ANTI-SWAY BAR (S) TOWARDS TRANSAXLE TOWARDS MOWER DECK 90° END INTEGRATED WASHER END Fig. 33 • From right side of mower, first insert 90° end of antisway bar (S) into hole in transaxle bracket (T), located near left rear tire in front of transaxle. NOTE: Flashlight may be helpful. ANTI-SWAY BAR (S) LOCATION TRANSAXLE BRACKET (T) LOCATED BETWEEN REAR TIRES TRANSAXLE 02965 BACK Q. DEFLECTOR SHIELD Fig. 31 4. SLIDE MOWER UNDER TRACTOR (See Fig. 32) • Bring belt forward and check belt for proper routing in all mower pulley grooves. NOTE: Ensure mower side suspension arms (A) are pointing forward before sliding mower under tractor. • Slide mower under tractor until it is centered under tractor. Q PLACE 90° END INTO HOLE S T S. ANTI-SWAY BAR T. TRANSAXLE BRACKET Fig. 34 NOTE: Depending on model, bracket (T) may be different than shown but hole for anti-sway bar will be in same position/location. • Pivot the integrated washer end of anti-sway bar (S) towards mower deck bracket on right side of mower. Insert integrated washer end of bar into hole in rear mower bracket (D). Move mower as needed to insert integrated washer end of bar into rear mower bracket (D). • Secure with small washer and small retainer spring as shown. A. MOWER SIDE A SUSPENSION ARMS Q. DEFLECTOR 02965 SHIELD Fig. 32 TS D Fig. 35 D. RIGHT SIDE REAR MOWER BRACKET S. ANTI-SWAY BAR T. TRANSAXLE BRACKET 20