Icom IC-V8000 Instruction Manual - Page 49
Scan start/stop
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
SCAN OPERATION 7 Scan start/stop D Preparation Scan resume condition (p. 42); program the scan edges (pgs. 39, 40); program 2 or more memory channels (pgs. 25, 26); set skip settings, if desired (p. 41). D Operation q Select VFO mode for full/programmed scan with [V/MHz(SCAN)]; or memory mode for memory scan with [M/CALL(PRIO)]. • Select the desired bank with [BANK(OPT)] for bank scan. w Set the squelch to the point where noise is just muted. e Push [V/MHz(SCAN)] for 1 sec. to start the scan. • To change the scanning direction, rotate the tuning dial. • The memory channel readout blinks the scan type as follows: r Push [SET(LOCK)] to switch full and programmed scan (P1, P2 and P3). t To stop the scan, push [V/MHz(SCAN)]. z Push [VFO/LOCK] to select VFO mode for SCAN full/programmed scan; push [MR/CALL] to select 2 memory mode for memory scan. • Push [BANK/OPTION] to select a bank for bank SET scan. B x Set the squelch to the point where noise is just muted. c Push [SCAN 2(T-SCAN)] to start the scan. 7 • Push [Y] or [Z] for 1 sec. also starts the scan. v Push [SET B(D-OFF)] to switch full and pro- grammed scan (P1, P2 and P3). b To stop the scan push [SCAN 2(T-SCAN)] or [CLR A(MW)]. • During full scan • During programmed scan • During memory scan Push [SET(LOCK)] to select full or programmed scan (P1, P2 and P3) in sequence. Indicates scan edge channels. • P1 stands for 1A/1b • P1 to P3 are available when they are programmed, and switches with [SET(LOCK)]. 38