Icom M93D Instruction Manual - Page 24

6 SCAN (Except for the Dutch version) ■■Setting Favorite channels You can quickly recall often-used channels by setting them as Favorite channels. You can set Favorite channels in each Channel Group. 1. Select a Channel Group. (p. 12) 2. Push [▲] or [▼] to select the channel you want to set as a Favorite channel. 3. Push [◄] or [►] to display . 4. Hold down the software key below for 1 second. ••The selected channel is set as a Favorite channel, and " " is displayed. LTo cancel the setting, hold down the key again for 1 second. TIP: You can set all channels as Favorite channels, clear all settings, or reset to the default. By default, some channels are preset as Favorite channels. The preset channels differ, depending on the transceiver version. Example: Starting a Normal Scan ■■Starting a scan 1. Select a Channel Group. (p. 12) 2. Push [◄] or [►] to display . 3. Push the software key below . ••The scan starts. ••" " is displayed during a Priority Scan, and " " is displayed during a Normal Scan. LWhen a signal is received, the scan pauses until the signal disappears, or resumes after 5 seconds, depending on the Scan Timer setting in "Radio Settings." LA beep sounds and "16" blinks when a signal is received on Channel 16 during a Priority scan. 4. To stop the scan, push the software key below . TIP: In order to properly receive signals, be sure to adjust the squelch to a suitable level. Push to start 17 While scanning " " is displayed. When a signal is received " " and " " are displayed.