Intel AXXRMS2LL080 Hardware User Guide - Page 15

2 Intel® RAID Module RMS2LL0x0 Hardware Installation Requirements • Intel® RAID Module RMS2LL040 and RMS2LL080, with the provided standoffs • A host system with one available 50-pins PCI Express* 2.0 connector • Resource CD, which contains drivers and documentation • SAS or SATA 6.0 hard drives • Four provided SAS/SATA cables (for cable requirements, see step 6 in "Installing the RAID Module") Note: Intel Corporation strongly recommends using an uninterruptible power supply (UPS). Installing the RAID Module To install the RAID Module, follow these steps: 1. Turn off the power to the system, all drives, enclosures, and system components. Remove the power cord(s). 2. Remove the server cover. For instructions, see your server system documentation. 3. Insert the three barrel standoffs into the matching holes in the server/workstation board. To locate the matching module card slot on your server/workstation board, see your server/workstation board documentation. The Intel® Server Board SR5520UR is shown for illustrative purpose. Actual standoff hole locations could be different (see Figure 1). 4. Attach the Intel®RAID Module RMS2LL0x0 to the matching server/workstation board connector, and press the module card firmly to engage the barrel standoffs installed in step 3 (see Figure 1). The Intel® RAID Module RM2LL080 is shown for illustrative purpose (see Figure 2). Intel® RAID Module RMS2LL040 and RMS2LL080 Hardware User's Guide 5