Intel CORE2DUO/T7300 Mechanical Design Guidelines - Page 101
Removing Excess Adhesive from IHS, Finished Thermocouple Installation
UPC - 735858193146
View all Intel CORE2DUO/T7300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Case Temperature Reference Metrology Figure 7-35. Removing Excess Adhesive from IHS 33. Using a blade, carefully shave any adhesive that is above the IHS surface (Figure 7-35). The preferred method is to shave from the edge to the center of the IHS. Note: The adhesive shaving step should be performed while the adhesive is partially cured, but still soft. This will help to keep the adhesive surface flat and smooth with no pits or voids. If there are voids in the adhesive, refill the voids with adhesive and shave a second time. 34. Clean IHS surface with IPA and a wipe. 35. Clean the LGA pads with IPA and a wipe. 36. Replace the land side cover on the device. 37. Perform a final continuity test. 38. Wind the thermocouple wire into loops and secure or if provided by the vendor back onto the plastic roll. (Figure 7-36). Figure 7-36. Finished Thermocouple Installation 39. Place the device in a tray or bag until it's ready to be used for thermal testing use. Thermal and Mechanical Design Guidelines 101