Intel RS25NB008 User Guide - Page 15
SAS/SATA Features, Online Capacity Expansion and RAID Level Migration Rules, Beep Codes, With OCE
View all Intel RS25NB008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
SAS/SATA Features • Provides eight independent phys, each supporting 6Gb/s and 3Gb/s SAS data transfers per PHY. • Scalable interface that supports up to 240 physical devices through expanders. • Supports SSP to enable communication with other SAS devices. • Supports SMP to communicate topology management information. • Supports single PHY or wide ports consisting of 2, 3, or 4 PHYs within a single quad port. • Allows addressing of multiple SATA targets through an expander if using SATA 2.0- compliant hard disk drives. • Single controller multi-pathing (fail-over). Online Capacity Expansion and RAID Level Migration Rules • Migration must occur to the same or larger capacity configuration. • Migration cannot occur if there is more than one virtual disk in a logical array. • Migration and OCE cannot be done on Spanned Arrays (RAID 10, 50, and 60). • Migrations supported are RAID 1 to RAID 0, RAID 5 to RAID 0, RAID 6 to RAID 0. • With OCE, migrations supported are RAID 0 to RAID 1, RAID 0 to RAID 5, RAID 0 to RAID 6, RAID 1 to RAID 5, RAID 1 to RAID 6, RAID 5 to RAID 6. Beep Codes • Short beep (1 second on, 1 second off): Array has degraded but no data has been lost. • Long beep (3 seconds on, 1 second off): Array has failed and data has been lost. • Short beep (1 second on, 3 seconds off): Using hot spare in rebuild; alarm will continue during rebuild with a different sound at completion. To disable the alarm, choose Disable Alarm. To enable the alarm, choose Enable Alarm. To disable the alarm only until the next event or until next power cycle, choose Silence Alarm. Intel® RAID Controller RS25NB008 Hardware User's Guide 5