Invacare 3GARBASE Owners Manual 2 - Page 106
Removing/Installing the 22NF Battery Box
View all Invacare 3GARBASE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
SECTION 10-BATTERIES NOTE: Make certain that the battery box carrying strap is positioned on top of the battery box and will not interfere with the one battery box guide pins when engaging the connector on the one battery box lid. 6. Secure the battery box carrying strap to the lid of the one connector battery box. 7. Place one connector battery box onto battery sub-frame. 8. Slide one connector battery box along the sub-frame until its guide pins are engaged in the connector of the two connector battery box. NOTE: Visually inspect to ensure the connection is properly made. Connectors MUST be fully engaged. CAUTION The battery box retainer MUST be locked securely to hold the battery boxes firmly in place or battery box connectors may be damaged causing erratic wheelchair operation. 9. Pull the battery box retainer down over the end of the one connector battery box until it is securely clipped (locked) into place. Removing/Installing the 22NF Battery Box NOTE: For this procedure, refer to FIGURE 10.8. NOTE: To install the battery box onto the wheelchair, reverse the following steps. 1. Place the wheelchair in a well ventilated area where work can be performed without risking damage to carpeting or floor covering. 2. Verify the joystick On/Off switch is in the Off position. 3. Disconnect the battery cable from the outside of the battery box. 4. Disconnect the battery box retention strap. 5. Remove the battery box. 6. Slide the four clips that secure the battery box cover to the battery box to the Open position. Arrows Battery Box Battery Box Retention Strap NOTE: Arrows on the battery box cover point to the open position. 7. Remove battery box cover from the battery box. FIGURE 10.8 Removing/Installing the 22NF Battery Box 3G Storm Series® Wheelchairs 106 Part No 1134791