Invacare 3GSEAT Owners Manual 2 - Page 98
Wheelchairs Equipped with MCC-MARK IV Joystick - Attach the battery charger
View all Invacare 3GSEAT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
SECTION 10-BATTERIES 1. Perform one of the following: • Wheelchairs Equipped with MCC-MARK IV Joystick - Attach the battery charger connector to the charger cable/battery harness. NOTE: The battery charger connector is factory installed on the right side of the wheelchair. It can be positioned on either side of the wheelchair for user convenience. NOTE: For Recliners Only - If the wheelchair is a recliner, the battery charger connector as well as the limit switch, are factory set on the right side of the wheelchair. However, they can be positioned on either side for user convenience. The limit switch MUST be positioned on the same side as the battery charger connector. • Torque SP Equipped with MARK IV RII Joystick- Attach the battery charger connector to the charger port on the Front of the joystick. 2. Plug the charger's AC power cord, or extension, into the grounded 120 VAC wall outlet. 3. Wait until charging is complete. NOTE: It is advantageous to recharge frequently rather than only when necessary. In fact, a battery's life is extended if the charge level is maintained well above a low condition. NOTE: If the batteries need to be charged more often or take longer to charge than normal, they may need to be replaced. Contact an Invacare dealer for service. 3G Storm Series® Wheelchairs 98 Part No 1134791