Invacare 9805 Owners Manual - Page 16

SECTION 4-ASSEMBLY SECTION 4-ASSEMBLY Assembly of the Patient Lift ƽ WARNING Use only Invacare parts in the assembly of this lift. The base legs, the mast, boom, pump assembly and the swivel bar are manufactured to specifications that assure correct alignment of all parts for safe functional operation. CAUTION DO NOT run the lift until it is fully assembled. Follow the assembly instrudctions in the Owner's Manual for proper assembly of this lift. Failure to do so could result in damage to the push handle of the lift, rendering it inoperative. NOTE: For this procedure, refer to FIGURE 4.1 and FIGURE 4.2. Base, Mast and Boom Assembly 1. Unpack the components from the shipping cartons. 2. Remove the locking screw from the bottom of the base. NOTE: The bottom of the mast assembly will have a notch. 3. Match the notch at the bottom of the mast assembly with the tabs inside the socket of the base assembly. Locking Screw Bolt and Locknut Bottom of mast notch 4. Insert the mast assembly into the socket and onto the tabs. 5. Turn the mast assembly to make sure that the notch is locked on the tabs of the socket. Top Inside of the Socket of the Base Assembly NOTE: If the mast does not turn, the mast is centered and locked in place. 6. Insert the locking screw into the bottom of the base and securely tighten. ƽ WARNING The mast may be removed from the base for storage or transporting. Each time the mast is removed and returned to the socket of the base, the mast MUST be locked into the socket of the base assembly. FIGURE 4.1 Assembly of the Patient Lift Base, Mast and Boom Assembly Portable Patient Lift and Sling 16 Part No 1024492