Invacare RPS350-1 Owners Manual - Page 11
Attaching the Battery Charger Mounting Bracket to the Wall
View all Invacare RPS350-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
SECTION 2-ASSEMBLY Attaching the Battery Charger Mounting Bracket to the Wall NOTE: For this procedure, refer to FIGURE 2.3. 1. Place the battery charger mounting bracket on the wall at the desired position. 2. With a pencil, mark the middle hole position. 3. Measure down 6½ inches from the pencil mark and drill one mounting hole. 4. Install the bottom mounting screw until there is an approximate 1/8‐inch gap between the screw head and the wall. 5. Put the battery charger mounting bracket onto the bottom mounting screw. 6. Drill the other two mounting holes. 7. Screw the mounting screws through the battery charger mounting bracket and into the wall. Tighten securely. CAUTION Make sure there is an audible click when mounting battery on the battery charger to confirm proper mounting. Otherwise, injury or damage may occur. Mounting Bracket Mounting Screws BOTTOM Mounting Screw FIGURE 2.3 Attaching the Battery Charger Mounting Bracket to the Wall 8. Put the battery charger in place on the mounting bracket. 9. Plug the battery charger into an electrical outlet. NOTE: An LED will illuminate when power is applied to battery charger. Part No. 1078984 11 Stand Up Patient Lift