Invacare TDXSP2 Owners Manual - Page 81
Using the Head Array, WARNING, Risk of serious injury
View all Invacare TDXSP2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
1. Activate utility function card. 2. Give input to front A to turn on horn. 3. Give short input to right B to turn on/off position lights. 4. Give short input to left C to turn on/off hazard lights. 5. Give long input to left or right D to turn on/off left or right turn signal. Activate a drive function card to drive normally, while position lights and hazard lights remain turned on. After more than ten seconds, the turn signals turn off automatically. 60101834-A Usage 5.15.8 Using the Head Array WARNING! Risk of serious injury Proximity sensors are sensitive to water. If enough water is present close to sensors, they may be activated and mobility device may start moving unintentionally. - Do not operate Head Array with wet hair. - Do not operate Head Array in wet weather. - Do not operate Head Array in any circumstances where water may come close to sensors. WARNING! Risk of serious injury Sensor pads are made of water resistant vinyl to get water quickly run off the pads before activating sensors. If sensor pads are damaged, water may get in and mobility device may start driving unintentionally. If sensor pads are covered by water absorbing material, mobility device may start driving unintentionally. - Do not operate Head Array if sensor pads are damaged. Change sensor pads immediately. - Do not cover sensor pads with any material. The Head Array is a three-quadrant operation. Inside the Head Array pads, there are proximity sensors, that allow you to steer the wheelchair in the desired direction with the movement of your head. This means that the head does not need to touch the pads or press a switch to activate driving. 81