JVC DT-N21H Instruction Manual - Page 7

Index of Parts and Functionos Rear panel 9 10 IN 1 RS-485 OUT Y 2 Pb Pr GPI OUT IN 3 CVBS RS-232C 1 VGA-IN 4 OUT IN 5 HDMI OUT1 IN1 OUT2 6 IN2 3G/HD/SD-SDI L R 7 AUDIO-IN Firmware upgrade 8 USB  REMOTE terminal Terminal for controlling the monitor by an external control ( "External Control" on page 17 ).  Y / Pb / Pr (IN) terminals (BNC)  CVBS terminals (BNC) Input (IN) and output (OUT) terminals for the composite signals.  VGA-IN (mini D-sub 15pin) Input terminal for analog RGB signal. ( page 22 )  HDMI terminal Input / Output terminal for HDMI signals. The monitor will not display or output HDMI with HDCP protection. ( page 22)  E. AUDIO 3G/HD/SD SDI (IN 1, IN 2) terminals (BNC) Input / Output terminals for the HD/SD SDI signals. The terminals accept also EMBEDDED AUDIO signals including up to 16 audio channels with a sampling frequency of 48 kHz.  AUDIO (IN) terminals (pin jack) Input terminals for the analog audio signals. Set signal source as ANALOG (CVBS, VGA, YPbPr) ,the analog audio can be monitored as audio meters or output via Speaker/Headphone.  USB socket  DC-IN terminal Main (Back up) power input, connect with DC11V 17V 4-pin XLR power adapter. (Pin 1: Negative, Pin 4: Positive)  AC-IN terminal AC power input connector. Connect the provided AC power cord to an AC outlet. CAUTION Do not connect the power cord until all other connections are completed. Note for connections • • Use a cord whose plugs correctly match the terminals on this monitor and the equipment. • • When unplugging a cord, be sure to grasp its plug and pull it out. • DO NOT connect the power cord until all connections are complete. • Refer also to the user manual of each piece of equipment. 7