JVC FS-H30 Instruction Manual - Page 10

AM antenna 1 Connecting Speakers 1 2 Vinyl-covered wire (not supplied) Speaker cord Speaker cord 2 AM loop antenna (supplied) Right speaker Left speaker 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. 2 Turn the AM loop antenna until you have the best reception. To connect an outdoor AM antenna When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected. For better reception of both FM and AM • Make sure the antenna conductors do not touch any other terminals and connecting cords. • Keep the antennas away from metallic parts of the unit, connecting cords, and the power cord. 1 Press and hold the clamp of the speaker terminal on the rear of the unit. 2 Insert the end of the speaker cord into the terminal. Match the polarity between the unit and the speaker terminals: ª to ª and · to ·. 3 Release your finger from the clamp. • DO NOT connect speakers while the power is on. • DO NOT connect more than one speaker to each speaker teminal. IMPORTANT: Use only speakers with the same speaker impedance as shown on the speaker terminals on the rear of the unit. 7