JVC FS-H35 Instruction Manual - Page 13

Common Operations

Get JVC FS-H35 PDF manuals and user guides View all JVC FS-H35 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Common Operations Continued Setting the Clock Before operating the unit any further, first set the unit's clock. When you plug in the power cord, the CLOCK indicator and "AM 12:00" start flashing on the display. You can set the clock whether the unit is on or off. • There is a time limit in doing the following steps. If the setting is canceled before you finish, start over from step 1. On the remote control: 1 Press CLOCK/TIMER. The hour digits start flashing on the display. CLOCK / TIMER CLOCK UP 2 Press UP or DOWN to adjust the hour, then press CLOCK/TIMER. DOWN The minute digits start flashing. CLOCK CLOCK / TIMER 3 Press UP or DOWN to adjust the minute, then press CLOCK/TIMER. CLOCK On the unit: 1 Press TIMER/SNOOZE. The hour digits start flashing on the display. TIMER/SNOOZE 3 Press ¢ or 4 to adjust the minute, then press TIMER/SNOOZE. To check the clock time during play On the remote control ONLY: Press DISPLAY (grey-colored). • Each time you press the button, the source indication and the clock time alternate on the display. DISPLAY • When you unplug the power cord or if a power failure occurs The clock is reset to "AM 12:00" right away. If this happens, set the clock again. • The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock. To change the clock 1 Make sure the (timer) indicator is not lit on the display. • If it is lit, press and hold CLOCK/TIMER (or TIMER/SNOOZE on the unit) until it goes off. 2 Press CLOCK/TIMER (or TIMER/SNOOZE on the unit) repeatedly until the unit enters the clock setting mode (the hour digits start flashing on the display). First time you press CLOCK/TIMER (or TIMER/ SNOOZE on the unit), the unit enters the timer setting mode. (See page 20.) 3 Repeat steps 2 and 3 of the procedure of "Setting the Clock." 4 Press and hold CLOCK/TIMER (or TIMER/ SNOOZE on the unit) again so that the (timer) indicator goes off. 2 Press ¢ or 4 to adjust the hour, then press TIMER/SNOOZE. The minute digits start flashing. TIMER/SNOOZE 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
10
Common Operations
Setting the Clock
Before operating the unit any further, first set the unit
’
s
clock. When you plug in the power cord, the
CLOCK
indicator and
“
AM 12:00
”
start flashing on the display.
You can set the clock whether the unit is on or off.
•
There is a time limit in doing the following steps. If
the setting is canceled before you finish, start over
from step
1
.
On the r
emote contr
ol:
1
Press CLOCK/TIMER.
The hour digits start flashing on the
display.
2
Press
UP or
DOWN to
adjust the hour, then press
CLOCK/TIMER.
The minute digits start flashing.
3
Press
UP or
DOWN to adjust the
minute, then press CLOCK/TIMER.
On the unit:
1
Press TIMER/SNOOZE.
The hour digits start flashing on
the display.
2
Press
¢
or
4
to
adjust the hour, then
press TIMER/SNOOZE.
The minute digits start flashing.
CLOCK
/ TIMER
CLOCK
CLOCK
CLOCK
TIMER/SNOOZE
DISPLAY
3
Press
¢
or
4
to adjust the minute,
then press TIMER/SNOOZE.
To check the clock time during play
On the r
emote contr
ol ONL
Y
:
Press DISPLAY (grey-colored).
•
Each time you press the button, the
source indication and the clock time
alternate on the display.
•
When you unplug the power cord or if a power failure
occurs
The clock is reset to
“
AM 12:00
”
right away. If this
happens, set the clock again.
•
The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
To change the clock
1
Make sure the
(timer) indicator is not lit on
the display.
•
If it is lit, press and hold CLOCK/TIMER (or
TIMER/SNOOZE on the unit) until it goes off.
2
Press CLOCK/TIMER (or TIMER/SNOOZE
on the unit) repeatedly until the unit enters the
clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER (or TIMER/
SNOOZE on the unit), the unit enters the timer
setting mode. (See page 20.)
3
Repeat steps
2
and
3
of the procedure of
“
Setting the Clock.
”
4
Press and hold CLOCK/TIMER (or TIMER/
SNOOZE on the unit) again so that the
(timer) indicator goes off.
UP
DOWN
CLOCK
/ TIMER
TIMER/SNOOZE
Continued