JVC FS-L30 Instruction Manual - Page 13
Reinforcing the Bass Sound, Selecting the Illumination Brightness, Adjusting the Volume
View all JVC FS-L30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Adjusting the Volume You can adjust the volume level only while the unit is turned on. The volume level can be adjusted between "VOL MIN" and "VOLUME 1" - "VOLUME 40 (VOL MAX)." When using the remote control, press VOLUME + to increase the volume or press VOLUME - to decrease it. When using the unit, turn VOLUME + / - clockwise (+) to increase the volume or counterclockwise (-) to decrease it. VOLUME VOLUME For private listening - + Connect the headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones. DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, a sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source next time. REMEMBER you cannot adjust the volume level while the unit is on standby. Adjusting the Tone (Bass/Treble) You can adjust the bass level (low frequency range) and the treble level (high frequency range) within the range of -5 to +5. Normally set these to 0 (initial setting at factory). • This function only affects the playback sound, but does not affect your recording. • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. 1 Press BASS to adjust the bass level or press TREBLE to adjust the treble level. BASS TREBLE BASS TREBLE Reinforcing the Bass Sound You can reinforce the bass sound to maintain rich, full bass at low volume. • This function only affects the playback sound, but does not affect your recording. To get the effect, press AHB (Active Hyper Bass) PRO until "AHB 1" or "AHB 2" appears on the display. The BASS indicator also lights up on the display. • Each time you press the button, the bass sound change as follows: AHB 1 AHB 2 AHB OFF (Canceled) AHB PRO AHB PRO BASS "AHB 2" has much more bass reinforcement effect than "AHB 1." To cancel the effect, press AHB PRO until "AHB OFF" appears on the display and the BASS indicator goes off. Selecting the Illumination Brightness You can change the illumination brightness only while the unit is turned on. On the remote control ONLY: To change the brightness, press DIMMER. DIMMER • Each time you press the button, the illumination dims and brightens alternately. 2 Press UP to increase the level or press DOWN to decrease it. UP DOWN UP DOWN - 10 -