JVC GZ MG330 Guide Book - Page 67
Troubleshooting
UPC - 689466111033
View all JVC GZ MG330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
ENGLISH Power FURTHER INFORMATION Troubleshooting The camera is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. The following phenomena are not malfunctions. • The camera heats up when it is used for a long time. • The battery heats up during charging. • When playing back a video file, the image stops momentarily or the sound is interrupted at junctions between scenes. • To solve the problem, first follow the instructions below. • If the problem is not solved, reset the camera. (੬ below) • If the problem persists, please consult your nearest JVC dealer. - To reset the camera 1) Close the LCD monitor to turn off the camera and remove the power supply (battery pack or AC adapter) from the camera, then reattach it. 2) Select [FACTORY PRESET] from the MENU. (੬ pg. 65) Trouble Action ੬ • Connect the AC adapter securely. 16 No power is supplied. • Detach the battery pack once again and reattach it firmly. 16 • Replace the dead battery with a fully charged one. - No display appears. • If the camera is not operated for 5 minutes while the power - is on, it turns itself off automatically to conserve power. To turn the camera on again when using the battery pack, close the LCD monitor and open it again. When using the AC adapter, perform any operation such as zooming. • Adjust the brightness of the LCD monitor. 64 • Move to a place where not affected by vibration or - The power was turned off accidentally. excessive sound. • The drop detection function operated. Close the LCD monitor and open it again. To turn off this function, set 64 [DROP DETECTION] to [OFF]. The displayed amount • Fully charge the battery, and then run it down. If the 16 of remaining battery problem persists, the battery is worn out and needs to be power differs from the replaced. Please purchase a new one. actual operating time. The power does not • Make sure to use the camera under appropriate operating 72 turn on, or the battery temperatures. operation time is • The battery is worn out and needs to be replaced. Please - extremely short even purchase a new one. after the battery is fully charged. The access/charge lamp on the camera does not light during charging. • Charging may stop in places subject to extremely high/low - temperatures to protect the battery. It is recommended to charge it in places with a temperature of 10°C to 35°C (50°F to 95°F). • When the battery is already fully charged, the lamp does 18 not light. Check the remaining battery power. 67