JVC KW-V240BT Instruction Manual America - Page 38
Bluetooth mobile phone
View all JVC KW-V240BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Bluetooth® 2 Select the device (1) you want to connect, then select [Connection] (2). Paired Device List Device Name 1 Device Name 2 Device Name 3 Device Name 4 Device Name 5 OK Connection Remove 3 Select the device (1) to connect, then return to the (2). BT Connection Settings Device Name Connected Connect Ready ON OFF ON OFF Select [ON] (to connect) or [OFF] (to disconnect). : Mobile phone : Audio device 4 Connect the selected device. Paired Device List Device Name 1 Device Name 2 Device Name 3 Device Name 4 Device Name 5 OK Connection Remove 36 ENGLISH • The status is shown as follows: - : Connection is in progress. - : A connection has been established. - : A connection can be established. - : Disconnection is in progress. - : No connection is established. • When a Bluetooth mobile phone is connected, the signal strength and battery level are displayed when the information is acquired from the device. To delete the registered device: Perform step 1, select the device you want to delete in step 2, then touch [Remove]. • A confirmation message appears. Touch [Yes]. Bluetooth mobile phone When a call comes in... 1 Device Name 1 2 Device Name 2 Incoming Call Name 1234XXXXXX Touching the operation keys performs the following actions: [ ] [ ] Answers a call. Rejects a call. • Call information is displayed if acquired. • Phone operation is not available while the picture from the rear view camera is displayed. During a call... 1 Device Name 1 Talking... 2 Device Name 2 Name 1234XXXXXX NR LEVEL - 0 + EC LEVEL - 0 + DTMF MIC LEVEL - 0 + Touching the operation keys performs the following actions: [ ] [ ]/ [ ] [DTMF] NR LEVEL [-] / [+] EC LEVEL [-] / [+] MIC LEVEL [-] / [+] Ends a call. Switches between handsfree mode and phone mode. Enters DTMF (Dual Tone Multi Frequency), then sends text using the keypad. Adjusts the noise reduction level. (-5 to 5, initial 0) Adjusts the echo volume level. (-5 to 5, initial 0) Adjusts the volume level of the microphone. (-10 to 10, initial -4) • Press + / - buttons on the monitor panel to adjust the volume of the call or earpiece.