Kenwood CA-CUT14 Operation Manual
Kenwood CA-CUT14 Manual
 |
View all Kenwood CA-CUT14 manuals
Add to My Manuals
Save this manual to your list of manuals |
Kenwood CA-CUT14 manual content summary:
- Kenwood CA-CUT14 | Operation Manual - Page 1
AND ENGINEERED FOR 2014-UP HARLEY-DAVIDSON® RUSHMORE MOTORCYCLES WITH FACTORY-STYLE HARD SADDLEBAGS INSTRUCTION MANUAL JVCKENWOOD Corporation Take the time to read through this instruction manual. Familiarity with installation and operation procedures will help you obtain the best performance from - Kenwood CA-CUT14 | Operation Manual - Page 2
Safety precautions WARNING The factory saddlebag hinges limit the size of the speaker magnet that can be used and allow the lids to open and close without issue. KENWOOD assumes ZERO RESPONSIBILITY for fitment issues, or water leaks when any speaker brand other than KENWOOD is used. Do Not Use " - Kenwood CA-CUT14 | Operation Manual - Page 3
Section 1 - Getting Started - Cont. 3. Locate the wire harness and take the 48" section with the silicone grommet in line and install it into the saddle bag, making sure the 2 speaker "spades" are on the inside of the bag and the single 2-pin connector is on the outside of the bag. The black squares - Kenwood CA-CUT14 | Operation Manual - Page 4
Section 2 - Disassembling The Factory Lid - Cont. 2. Remove the 2 screws that hold the "key lock" to the factory lid. The chrome panel with the reflector built-in comes off the factory lid by removing the 3 screws right next to the key lock. At its seam, the factory foam gasket needs to be peeled - Kenwood CA-CUT14 | Operation Manual - Page 5
Section 3 - Mounting The Templates - Cont. We Strongly suggest using a blade made SPECIFICALLY FOR PLASTICS. When cutting your lid with the correct blade, there should be ZERO smell of burning plastic! Incorrect blades will do more melting than cutting. CUTTING THE GRILLE OPENING 4. For cutting, we - Kenwood CA-CUT14 | Operation Manual - Page 6
Section 3 - Mounting The Templates - Cont. CLUTCH SIDE LID 6. Place the lid upside down on a blanket or something similar to protect its painted surface. Locate the speaker adaptor marked "Clutch", noting that it only fits one way. In the order shown, put "thread forming" screws through the - Kenwood CA-CUT14 | Operation Manual - Page 7
Section 4 - Wiring The Saddelbags For Speakers NOTE: The pre-terminated spade connectors on the harness inside the bag are correct for KENWOOD speakers but may need to have new terminals installed for other speakers. The larger connector (colored wire) is negative, and the smaller connector (black) - Kenwood CA-CUT14 | Operation Manual - Page 8
and/or its affiliates. All other trademarks are the property of their respective owners. Specifications subject to change without notice. For updated information (the latest Instruction Manual, etc.), please visit the following website: https
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best performance from your new product.
© 2023 JVCKENWOOD Corporation
CA-CUT14
CUT-IN LID KIT FOR 6” X 9” SPEAKERS DESIGNED AND ENGINEERED
FOR 2014-UP HARLEY-DAVIDSON® RUSHMORE MOTORCYCLES WITH
FACTORY-STYLE HARD SADDLEBAGS
INSTRUCTION MANUAL
JVCKENWOOD Corporation