Kenwood CA-LID98 Operation Manual - Page 7
Wiring The Lids To The Amplifier
View all Kenwood CA-LID98 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Section 6 - Routing The Speaker Wire Harness - Cont. For FLH (Batwing) Models, the harness will pass under the inner fairing where the main wire harness passes through on the brake side of the bike. For FLTR (Road Glide) Models, the harness will pass through the inner fairing where the factory wires pass. 1. Loosen the tank console and run the wires up and over the gas tank, but under the tank console. There is a provision on the front of the tank console for wires to pass Note: You "can" lift the tank if you want but it is not required. Once past the battery, the harness will continue towards the back of the bike along the frame, and when correctly installed, the two 2-pin plugs will be beside the back seat on the brake side of the bike. 2. Secure the harness to the bike's factory harness using zip ties, plug the brake side lid in, and then run the clutch side under the seat and plug it in. Section 7 - Wiring The Lids To The Amplifier NOTE: The 4-pin connector will plug into the KENWOOD XM160-2-98 amplifier. If you're using another brand of amplifier, you will see that the wires near the 4-pin plug are labeled. Simply cut the plug off and wire the lids to your amp using the labels to identify each wire. 7