Kenwood KAC-746 User Manual - Page 6

Connection sRCA cable connection CENTER UNIT (Cassette receiver, CD receiver, etc.) BLINE IN (Rear) Power control cable POWER IN GND BATT P.CON(REMOTE) ALINE IN (Front) RCA cable (Commercially available part) 2CAUTION Do not connect cables and leads to both RCA cable input jacks and the speaker input terminals simultaneously, for this may cause malfunction or damage. A Left input (White) B Left input (White) GND 100 80 100 150 80 FILTER INPUT SENSITIVITY(V) 0.5 0.3 OPERATION 150 OFF 1.0 HPF LPF 50 LPF 200 50 HPF 200 MIN MAX FREQUENCY(Hz) STEREO MONO(Lch) L {R AB MONO L R A CONTROL A INPUT SELECTOR A LINE IN B A {B LINE OUT INPUT L SENSITIVITY(V) 0.5 0.3 OPERATION FILTER 100 80 150 100 80 1.0 OFF 150 HPF LPF MIN R MAX STEREO MONO(Lch) L {R 50 LPF 200 50 HPF 200 FREQUENCY(Hz) CONTROL B 4 CHANNEL POWER AMPLIFIER A Right input (Red) B Right input (Red) RCA cable ground terminal 2CAUTION When using an RCA cable with Do not use this terminal for power source a ground lead attached, connect grounding. This unit will be damaged if the the ground lead to this terminal. power source grounding wire is connected to this terminal. sSpeaker level input connection Connect the unit by inserting it in the connection between the genuine-accessory car stereo and speakers. -+ Battey ACC Power control (REMOTE) lead terminal A Left input (Front left) A Right input (Front right) Front FUSE(30A) POWER IN GND BATT P.CON(REMOTE) SPEAKER OUTPUT BRIDGED A A B L RB BRIDGED LEFT RIGHT SPEAKER LEVEL INPUT LEFT RIGHT A SPEAKER LEVEL INPUT A B B L R Genuine-accessory car stereo 2CAUTION B Left input (Rear left) B Right input (Rear right) • The genuine-accessory car stereo shall have a maximum power output of no more than 25 W. Rear • Do not connect the speaker output leads from a power amplifier (Optional) to the speaker input terminals of this unit, for this may cause malfunction or damage. • Do not connect cables and leads to both RCA cable input jacks and the speaker input terminals simultaneously, for this may cause malfunction or damage. • Connect the power control lead to a power supply which can be turned ON/OFF by the ignition key switch (ACC line). With this connection, shock noise may be generated when the power of the genuine-accessory car stereo is switched ON/OFF. 6