Kenwood KDC MP438U Instruction Manual - Page 20

Installation non-Japanese cars Metal mounting strap (commercially available) Firewall or metal support Removing the hard rubber frame 1 Engage the catch pins on the removal tool and remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure. \ Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Self-tapping screw (commercially available) Screw (M4X8) (commercially available) ~ ~ Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). Japanese cars 1 Refer to the section and then remove the hard rubber frame. 2 Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws. ~ ,+L-. IT/N T@ @N @@ NT /1 TToyota cars N: Nissan cars !?-=r ~~8mm smm MAX. MAX. H@ I-..H~ 0Smm 05mm [email protected] Nissan car [email protected] car Accessory@ Removal tool 2 When the upper level is removed, remove the lower two locations. ~ ~ • The frame can be removed from the bottom side in the same manner. Removing the Unit 1 Refer to the section and then remove the hard rubber frame. 2 Remove the screw (M4 x 8) on the back panel. 3 Insert the two removal tools deeply into the slots on each side, as shown. 4 Lower the removal tool toward the bottom, and pullout the unit halfway while pressing towards the inside. Screw (M4X8) (commercially available) / Accessory@ &'" ~ • Be careful to avoid injury from the catch pins on the removal tool. 5 Pull the unit all the way out with your hands, being careful not to drop it. I 20 KDC-X492/KDC-MP438U/KDC-MP408U/KDC-MP338