Kenwood KDC MP5032 Instruction Manual - Page 11

Adjustment Item Display Front High Pass Filter*2 "HPF" Rear High Pass Filter*2 "HPR" Low Pass Filter*1,2 "LPF" Subwoofer Phase*1,2,3 "PHAS" Volume offset "V-OFF" Loudness "LOUD" Dual Zone System "2ZON" Range Through/40/60/80/100/120/ 150/180/220 Hz Through/40/60/80/100/120/ 150/180/220 Hz 50/60/80/100/120/ Through Hz Reverse (180°)/ Normal (0°) -8 - ±0 OFF/ON OFF/ON • Volume offset: Sets each source's volume as a difference from the basic volume. • Loudness: Compensates for low and high tones during low volume. When Loudness is ON, "LOUD" indicator is ON. • *1 You can control this item when (page 12) is set to "SW ON". • *2 You can control this item when "2ZON" of (page 10) is set to "OFF". • *3 You can control this item when Low Pass Filter is not set to Through. • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - Set up the channel of sub source by (page 24). - Select Main source by [SRC] button. - Adjust the volume of Front channel by [VOL] knob. - Adjust the volume of Rear channel by (page 10). - The Audio Control has no effect on sub source. • You can use the Dual Zone System with the Auxiliary input sources listed below. - Option CA-C1AX/ CA-C2AX 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "STANDBY" display. 2 Enter Speaker Setting mode Press the [VOL] knob. 3 Select the Speaker type Turn the [VOL] knob. Each time you turn the knob, the setting alternates between the settings shown in the table below. Speaker type OFF For 5 & 4 in. speaker For 6 & 6x9 in. speaker For the OEM speaker Display "SP OFF" "SP 5/4" "SP 6x9/6" "SP OEM" 4 Exit Speaker Setting mode Press the [VOL] knob. English | 11