Kenwood KDC MP5032 Instruction Manual - Page 24

Menu system In Standby mode Built-in Amp Setting Controlling the built-in amplifier. Turning OFF this control enhances the preout quality. Display "AMP ON" "AMP OFF" Setting The built-in amplifier activates. The built-in amplifier deactivates. In FM reception CRSC (Clean Reception System Circuit) Temporarily have reception alternate from stereo to mono to reduce multi-path noise when listening to the FM station. Display "CRSC ON" "CRSC OFF" Setting The CRSC is ON. The CRSC is OFF. Other than Standby mode/ When the Dual Zone System is ON Dual Zone System Setting Setting the Front channel and Rear channel sound in the Dual Zone System. Display "ZONE2 R" "ZONE2 F" Setting Sub source (Auxiliary input source) is to be rear channel. Sub source (Auxiliary input source) is to be front channel. In Audio file source Supreme Setting When AAC, MP3 or WMA files encoded at a low bit rate (less than 96kbps (fs=32k, 44.1k, 48kHz)) are played, this function restores their high frequency region to approach the sound quality of equivalents of these files encoded at a high bit rate. Processing is optimized for the compression format used (AAC, MP3, or WMA), and adjustment is made for the bit rate used. Display "SPRM ON" "SPRM OFF" Setting Plays sound using the Supreme function. Plays the original sound stored in the audio file. • The sound effect may be imperceptible depending on the relationship between the audio file format and setting. • Strong electrical fields (such as from power lines) may cause unstable sound quality when CRSC is turned ON. In such a situation, turn it OFF. In HD Radio mode Receive mode Setting Sets the receive mode. 1 Select the Receive mode Push the Control knob towards [FM] or [AM]. Select the "HDR MODE" display. 2 Enter Receive mode Press the Control knob for at least 1 second. 3 Set the Receive mode Push the Control knob towards [FM] or [AM]. Each time you push the knob, the Receive mode alternates between the modes shown in the table below. Receive mode Auto mode Digital Analog Display "AUTO" "DIGITAL" "ANALOG" Operation Analog broadcasts and digital broadcasts will be switched automatically. When both are being transmitted, the digital broadcast will have priority. Digital broadcasts only. Analog broadcasts only. 4 Exit Receive mode Press the [MENU] button. 24 | English • Even if the Receive mode is set to "AUTO", when the Ball game mode program (non-delayed broadcast program) is received, the Receive mode will automatically switch to Analog broadcast only.