Kenwood KMM-BT304 Instruction Manual 2 - Page 31

REFERENCES Source name Display information STANDBY Source name Clock (back to the beginning) RADIO Frequency Clock (back to the beginning) (For FM Radio Data System only) Station name Radio text Radio text+ Title/Artist Frequency Clock (back to the beginning) USB (For MP3/WMA/AAC/WAV/FLAC files) Song title/Artist Album title/Artist Folder name File name Playing time Clock (back to the beginning) iPod USB/ iPod BT or ANDROID When [MODE OFF]/[BROWSE MODE] is selected ( 9): Song title/Artist Album title/Artist Playing time Clock (back to the beginning) PANDORA/ PANDORA BT Station name Shared/Radio station Song title Artist Album title Playing time Clock (back to the beginning) SPOTIFY/ SPOTIFY BT Context title Song title Artist name Album name Playing time Clock (back to the beginning) BT AUDIO Song title/Artist Album title/Artist Playing time Clock (back to the beginning) AUX Source name Clock (back to the beginning) INSTALLATION/CONNECTION Warning • The unit can only be used with a 12 V DC power supply, negative ground. • Disconnect the battery's negative terminal before wiring and mounting. • Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to prevent a short circuit. • To prevent short circuit: - Insulate unconnected wires with vinyl tape. - Be sure to ground this unit to the car's chassis again after installation. - Secure the wires with cable clamps and wrap vinyl tape around the wires that come into contact with metal parts to protect the wires. Caution • For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer. • Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot. • Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connect them in parallel. • Mount the unit at an angle of less than 30º. • If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red) to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on and off by the ignition key. • Keep all cables away from heat dissipate metal parts. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old fuse with one that has the same rating. Basic procedure 1 Remove the key from the ignition switch, then disconnect the [ terminal of the car battery. 2 Connect the wires properly. See Wiring connection. ( 33) 3 Install the unit to your car. See Installing the unit (in-dash mounting). ( 32) 4 Connect the [ terminal of the car battery. 5 Press to turn on the power. 6 Detach the faceplate and reset the unit within 5 seconds. ( 3) ENGLISH 31