Kenwood SW10 Instruction Manual - Page 8
Operation, Fuse exchange - powered subwoofer
UPC - 019048175748
View all Kenwood SW10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
ENGLISH LEVEL Operation Name of each part (Remote control) PHASE switch (Phase select switch) FREQUENCY control knob (Cut-off frequency control knob) LEVEL control knob (Input sensitivity control knob) Power indicator (Power display light) Power indicator Red glows Light is OFF The illumination on the subwoofer turns on and off in an interlocked operation with the PWR indicator on the remote control unit. Illumination Power ON Power OFF Adjusting the sound (Remote control operation) 1 Turn the FREQUENCY control knob to adjust the cut-off frequency (frequencies higher than this frequency are cut off). Turn the FREQUENCY control knob to adjust the balance between the bass from the rear speakers and the bass from this unit as desired. MAX 2 Turn the LEVEL control knob to adjust the low frequencies to the desired level. MIN LOW FREQUENCY HIGH 3 Adjust the low frequency phase. The low frequency tone may be variable depending on the position of the unit, its orientation or the turn-over frequency. This can be adjusted by changing the position of the PHASE switch. Set this switch to either position according to your liking. [[0°] indicates the normal phase and [180°] means the reverse phase. Fuse exchange Exchange with the specified capacity fuse. Removal Fuse Cover Caution: Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 10A. Insertion Replacement fuse 10 A Fuse holder 1 Open the cover. 2 Grasp with pliers and pull up. English 1 Insert the fuse gently into the fuse holder and push in all the way with your finger. 2 Close the cover.