Kenwood TK3101K2 Instruction Manual - Page 14
holding the, Monitor, rotating
View all Kenwood TK3101K2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
OPERATING BASICS ALVORMIWARRIVIRSig o•routre III r 1 Switch ON the transceiver by turning the Power switch/ Volume control clockwise. (3O-77-t • A beep sounds. 2 Adjust the volume by pressing and holding the Monitor key, then rotating the Power switch/ Volume control. 3 Rotate the Channel selector to choose your desired channel. • When you receive an appropriate signal, you will hear audio from the speaker. 4 To make a call, press and hold the PTT switch, then speak into the microphone using your normal speaking voice. • Hold the microphone approximately 1.5 inches (3 to 4 cm) from your lips. 5 Release the PTT switch to receive. Note: • The channelinuse mayhave beenprogrammed with a signalling code, Refer to "QUIET TALK PT onpage a • When the batterypack voltage becomes too low, transmission willstop and the LED willblink red. Refer to tow Battery Waming"on page 15. li 1- ` I orminweastnimigMgrOMMW=wzo.=::z-mmmMig 7 k.• 555