Kenwood TM-271A User Manual - Page 31
Automatic Repeater Offset, Transmitting A 1750 Hz Tone
View all Kenwood TM-271A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
AUTOMATIC REPEATER OFFSET This function automatically selects an offset direction, according to the frequency on the VHF band. The transceiver is programmed for an offset direction as shown below. To obtain an up-to-date band plan for repeater offset direction, contact your national Amateur Radio association. K market version only 144.0 145.5 146.4 147.0 147.6 145.1 146.0 146.6 147.4 148.0 MHz S- S + S- +S - S: Simplex This complies with the standard ARRL band plan. E market version only 144.0 145.6 145.8 146.0 MHz S -S S: Simplex Note: Automatic Repeater Offset does not function when the Reverse function is ON. However, pressing [REV] after Automatic Repeater Offset has selected an offset (split) status, exchanges the receive and transmit frequencies. 1 Press [F], [MENU] and turn the Tuning control to select Menu No. 11 (ARO). 2 Press [MENU] and turn the Tuning control to switch the function "ON" (default) or "OFF". 3 Press [MENU] to store the setting or any other key to cancel. 4 Press any key other than [MENU] to exit Menu Mode. TRANSMITTING A 1750 Hz TONE Call Channel default settings: • On E market models, pressing [CALL] causes the transceiver to transmit a 1750 Hz tone. • On K and M market models, pressing [CALL] changes the transceiver to the Call Channel {page 35}. Most of the repeaters in Europe require the transceiver to transmit a 1750 Hz tone. To change the setting of the CALL key: 1 Press [F], [MENU] and turn the Tuning control to select Menu No. 19 (CK). 2 Press [MENU] and turn the Tuning control to select 6 "CALL" or "1750". 3 Press [MENU] to store the setting or any other key to cancel. 4 Press any key other than [MENU] to exit Menu Mode. Some repeaters in Europe must receive continuous signals for a certain period of time, following a 1750 Hz tone. This transceiver is also capable of remaining in the transmit mode for 2 seconds after transmitting the tone. 1 Press [F], [MENU] and turn the Tuning control to select Menu No. 20 (HLD). 2 Press [MENU] and turn the Tuning control to select "ON" or "OFF" (default). 3 Press [MENU] to store the setting or any other key to cancel. 4 Press any key other than [MENU] to exit Menu Mode. 25