Kenwood VR-5900 User Manual 1 - Page 41
Calibrating the Touch Screen, Selecting the Model Type, Remote Setup
View all Kenwood VR-5900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter Two : Setting Up PowerTouch III Calibrating the Touch Screen After you install the batteries or reset PowerTouch III, you need to calibrate the touch screen. The touch screen responds to pressure from the included stylus or your finger: To calibrate the touch screen, use the stylus to touch the center of each of the calibration points displayed: Resetting PowerTouch III If you want to reconfigure PowerTouch III, you can reset it. You do not need to do this unless you experience a problem. 1. Open the cover. 2. Use the stylus to press the blue button at the bottom of the battery case: Remote Setup If you are replacing batteries and complete the battery replacement within 3 minutes, you do not need to calibrate the screen; calibration is stored in memory. If the screen's performance begins to change, you can recalibrate it without resetting PowerTouch III by pressing on the Setup menu. For more information about accessing this menu, see "Identifying Devices For PowerTouch III Control" on page 40. When you touch each calibration point, you should hear a beep and see the next point, indicating that area of the screen is now calibrated. If you do not hear a beep, touch the calibration point until you do. The touch screen is sensitive to pressure, not to movement. Press firmly but gently on any touch screen element. The screen will not respond if you simply brush the stylus or your finger along the surface. 3&4&5 The items you set up in this chapter will remain in 35 PowerTouch III. If you want to make it to the factory-set default condition, please follow the instructions on page 104 of the Users' Guide. After "Calibrating the Touch Screen", the "Selecting the Model Type" display appears automatically. The model type selection is performed to let the PowerTouch III recognize the type of the receiver you have. Once the model type is selected, it does not have to be selected again even after PowerTouch III is reset. Selecting the Model Type To set the model type: 1. Press the receiver's ON STANDBY button to turn it ON. 2. Aim the PowerTouch III towards the receiver and press the in the display. 3. The receiver automatically transmits its type code to PowerTouch III. When the PowerTouch III stores it, the model type selection is complete. Now the new PowerTouch III is available for operation. • If the model type cannot be selected automatically because the receiver is not ON, etc., the model type can be selected manually. In this case, select the "Model 1" in step 2 above. If you committed mistake in the model type selection, restart it as follows. • While holding the CONFIRM and VOLUME DOWN buttons together, press and release the RESET button under the battery cover (see above diagram). Do not release the CONFIRM and VOLUME DOWN buttons until a short beep indicating the completion of setting is heard. After the above, all settings are reset to the factory settings.