Kenwood VR-60RS User Manual - Page 6

Names and functions of parts Main Unit Speaker indicator AUTO indicator Frequency display, Input display, Preset channel display, AUTO DETECT indicator Surround mode display DIGITAL indicator DSP MODE Band indicators indicator CLIP indicator MUTE indicator LOUDNESS indicator TONE indicator TUNED indicator ST. indicator Input channel indicators *The Input channel indicators light up to indicate the channels contained in the input signal. The "S" indicator lights when the surround component consists of a single channel. Display DOLBY DIGITAL indicator PRO LOGIC indicator NEO:6 indicator DTS indicator DISCRETE 6.1 indicator MATRIX 6.1 indicator 1 POWER ON/STANDBY key ^ Use to turn the power ON/STANDBY. STANDBY indicator 2 DIMMER key Use to select the REC MODE. ) Use to adjust the brightness of the display. ¶ 3 LISTEN MODE key ∞ Use to select the listening mode. 4 Surround LED (light-emitting diode) indicators ACTIVE EQ mode LED indicator ) Lights when this model is in the ACTIVE EQ mode. DTS mode LED indicator ∞ Lights when this model is in the DTS mode. DOLBY DIGITAL mode LED indicator ∞ Lights when this model is in the Dolby Digital mode. 5 SOUND key ¶ Use to adjust the sound quality and the ambience effects. 6 MULTI CONTROL knob ^ Use to control a variety of settings. 7 INPUT SELECTOR knob * Use to select the input sources. 8 VOLUME CONTROL knob ( 9 PHONES jack ) Use for headphone listening. 0 SPEAKERS ON/OFF key * Use to turn the speakers ON/OFF. ! ACTIVE EQ key ) Use to select ACTIVE EQ setting. @ INPUT MODE key 8 Use to switch between full auto, digital and analog inputs. # BAND key ¡ Use to select the broadcast band. $ AUTO/MONO key Use to change "TAPE" indication to "MD". * Use to select the auto tuning mode. ¡ % MEMORY key ™ Use to store radio stations in the preset memory. ^ SETUP key ^ Use to select the speakers' settings etc. & MUTE key ) Use to temporarily mute the sound. Standby mode While the standby indicator is lit, a small amount of power is supplied to the system to back-up the memory. This is called standby mode. Under the condition, the system can be turned ON by the remote control unit. 6 EN CAUTION The power in this equipment will not be completely cut off from the AC wall outlet when the main switch is turned OFF.