KitchenAid KBFS22EWBL Use & Care Guide - Page 10
Install Air Filter
View all KitchenAid KBFS22EWBL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Style 2 1. Unplug refrigerator or disconnect power. 2. Remove and discard the plastic part that is attached to the inlet of the water valve. 3. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. 4. Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall. 5. Turn shutoff valve ON. 6. Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak. A B C D E A. Tube clamp B. Tube clamp screw C. Copper tubing D. Compression nut E. Valve inlet 7. On some models, the ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer. Style 3 1. Unplug refrigerator or disconnect power. 2. Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator. 3. If the gray water tube supplied with the refrigerator is not long enough, a ¹⁄₄" x ¹⁄₄" (6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing. NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. Complete the Installation WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Flush the water system. See "Water and Ice Dispensers" in the User Instructions or User Guide. NOTE: Allow 24 hours to produce the first batch of ice. Allow 72 hours to completely fill ice container. Install Air Filter (on some models) On some models, your refrigerator's accessory packet includes an air filter, which must be installed prior to use. On some models, the air filter is already installed at the factory. AB CD A. Refrigerator water tubing B. Nut (provided) C. Bulb D. Coupling (purchased) EFG E. Ferrule (purchased) F. Nut (purchased) G. Household water line 4. Turn shutoff valve ON. 5. Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak. The air filter reduces the buildup of odors. This helps to maintain a cleaner environment inside the refrigerator. Installing the Air Filter (on some models) The filter should be installed behind the vented door, which is located (depending on your model) along either the rear or left interior wall near the top of the refrigerator compartment. 1. Remove the air filter from its packaging. 2. Lift open the vented door. 10