KitchenAid KBLS22ETSS Use and Care Manual - Page 17

Temp Alarm The Temp Alarm feature provides temperature information in the event of a power outage. Power Outage: During a power outage, if the temperatures in the refrigerator and freezer compartments exceed normal operating temperatures, the highest temperature reached will be displayed. ■ Press the Temp Alarm touch pad until the indicator light is lit, to turn on this feature. Press and hold Temp Alarm for 3 seconds until the indicator light goes off to turn off this feature. Temperature Alarm: An alarm will sound repeatedly if the freezer or refrigerator compartment temperatures exceed normal operating temperatures for an hour or more. The temperature displays will alternately show the current temperatures and the highest temperatures the compartments reached. ■ Press the Temp Alarm touch pad once to stop the audible alarm and alternating temperature displays. The Temp Alarm light will continue to flash until the refrigerator returns to the set temperature. Door Alarm The Door Alarm feature sounds a chime every few seconds when the refrigerator door has been left open for 5 continuous minutes. The chime will sound until the door is closed or Door Alarm is turned off. ■ Press the Door Alarm touch pad to turn this feature on or off. The indicator light will be lit when the Door Alarm feature is on. To Access the User Preferences Menu: 1. Press and hold the Door Alarm touch pad for 3 seconds. The preference name will appear in the Freezer display and the preference status (F or C) or (ON or OFF) will appear in the Refrigerator display. 2. Use the Freezer (+) or (-) touch pads to scroll through the preference names. When the desired preference name is displayed, press the Refrigerator (+) or (-) touch pads to change the preference status. 3. Set your preferences by pressing and holding the Door Alarm touch pad for 3 seconds, or by shutting the refrigerator compartment door. Water Dispenser (on some models) If you did not flush the water system when the refrigerator was first installed, dispense water into a container until you draw and discard 2 to 3 gal. (8 to 12 L) or for approximately 6 to 7 minutes after the water begins dispensing. The water you draw and discard rinses the pipes. Allow several hours for the refrigerator to cool down and chill water. Dispensing Water 1. Hold a container under the dispenser while pressing the button. 2. Release the button to stop dispensing. NOTE: Dispense enough water every week to maintain a fresh supply. Water Filter Status Light and Filter Reset (on some models) See "Water Filter Status Light." Digital Control User Preferences The control center allows you to set user preferences, if desired. Temperature Display (F_C) This preference allows you to change the temperature display. F - Temperature in degrees Fahrenheit C - Temperature in degrees Celsius Alarm (AL) This preference allows you to turn off the sound of all alarms. ON - You will hear the alarm sound. OFF - You will not hear the alarm sound. Sabbath Mode (SAB) IMPORTANT: This preference does not disable interior lights. ON - All control panel lights will be disabled. OFF - All control panel lights will be enabled. NOTE: Press any touch pad on the control panel to restore the control panel lights. Water Filter Status Light (on some models) The water filter status light will help you know when to change the water filter. When the yellow (Order) light is on, it is almost time to change the water filter. When the red (Replace) light is on, a new water filter should be installed. See "Water Filtration System." After replacing the water filter, press and hold FILTER RESET for 3 seconds until the Order or Replace light turns off. 17