KitchenAid KBSS271TSS Installation Instructions - Page 14
Low Flame Adjustment
View all KitchenAid KBSS271TSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
5. Remove the 2 screws that hold the burner in place. Remove gas burner from the grill. A A. 2 screws 6. If flame is yellow (not enough air), turn air shutter adjustment screw counterclockwise. If flame is noisy or lifts away from burner (too much air), turn air shutter adjustment screw clockwise. Low Flame Adjustment If flame goes out on the "LO" setting, the low flame setting must be adjusted. 1. Turn off the valve and wait until grill and burners are cool. 2. Remove grill grates and sear plates. 3. Light grill using information in the "Outdoor Grill Use" section. 4. Turn burner to its lowest setting and remove knob. 5. Hold valve stem with pliers and insert a small flat-blade screwdriver into the shaft. 6. Watch the flame and slowly turn the screwdriver counterclockwise. 7. Adjust flame to minimum stable flame. A A A. Air shutter adjustment screw Adjustment should be made clockwise or counterclockwise from ¹⁄₈" (3.2 mm) to ¹⁄₄" (6.4 mm). 7. Replace gas burner, sear plates and grates. 8. Light grill using information in the "Outdoor Grill Use" section. See "Burner Flame Characteristics." B C A. Valve stem B. Small flat-blade screwdriver C. Pliers 8. Replace the control knob and turn off the burner. 9. Repeat steps 3 through 8 for each burner if needed. 10. Replace the sear plates and grates after the burners have cooled. 14