KitchenAid KODE900HSS Installation Instructions - Page 2

BUILT-IN OVEN SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." These words mean: DANGER You can be killed or seriously injured if you don't immediately follow instructions. WARNING You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed ■■ Phillips screwdriver ■■ Measuring tape ■■ Flush Installation Kit (for Single and Double installed at flush installation) Order Part Number W10752683 for stainless steel 30" (76.2 cm) kit Order Part Number W10752682 for black stainless steel 30" (76.2 cm) kit To order, see the "Assistance or Service" section of the Use and Care Guide. ■■ Hand or electric drill (for wall cabinet installations) ■■ 1" (2.5 cm) drill bit (for wall cabinet installations) ■■ Level Parts Supplied ■■ #8-14 x 3/4" (1.9 cm) screws - single ovens (2), double ovens (4) ■■ Flat-blade screwdriver ■■ #8-18 x 3/8" (9.5 mm) screws - bottom vent (2) Parts Needed ■■ UL Listed or CSA Approved conduit connector ■■ UL Listed wire connectors ■■ Warming Drawer Deflector Kit (for ovens installed above a warming drawer) Order Part Number W10536339 for stainless steel 30" 76.2 cm) kit Order Part Number W10727416 for black stainless steel 30" (76.2 cm) kit To order, see the "Assistance or Service" section of the Use and Care Guide. ■■ #8-18 x 1/4" (6.4 mm) screws - bottom vent trim (4) ■■ #8-18 x 3/8" (9.5 mm) screws - double oven feet (4) ■■ Bottom vent ■■ Rear feet - double oven (2) ■■ Front feet - double oven (2) Check local codes. Check existing electrical supply. See the "Electrical Requirements" section. It is recommended that all electrical connections be made by a licensed, qualified electrical installer. 2