KitchenAid KRBX109EWH User Instructions - Page 6
Refrigerator Door and Drawer
View all KitchenAid KRBX109EWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Style 2 1. Create a service loop (minimum diameter of 2 ft [61 cm]) with the copper tubing. Avoid kinks when coiling the copper tubing. 2. Remove the plastic cap from water valve inlet port. Place a compression nut and sleeve on the copper tubing. 3. Insert the end of the copper tubing into the water valve inlet port. Shape tubing slightly so that the tubing feeds straight into the port to avoid kinks. 4. Slide the compression nut over the sleeve and screw into the water valve inlet port. A B C D A. Plastic water tubing C. Compression nut B. Sleeve D. Copper tubing 5. Using an adjustable wrench, hold the nut on the plastic water line to keep it from moving. Then, with a second wrench turn the compression nut on the copper tubing counterclockwise to completely tighten. Do not overtighten. A B C D A. "P" clamp B. Plastic water line C. Compression nut D. Copper tubing 6. Check connection by pulling on copper tubing. Attach the plastic water line to the refrigerator cabinet with a "P" clamp. 7. Turn on water supply to the refrigerator and check for leaks. Correct any leaks. Complete the Installation WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice storage bin. Refrigerator Door and Drawer All graphics referenced in the following instructions are included later in this section after "Final Steps." TOOLS NEEDED hex-head socket wrench, a hex key, #2 Phillips screwdriver, and a flat-blade screwdriver. Remove and Replace Handles 1. Using a hex key, loosen the two setscrews located on the side of each handle. See graphics 2 and 4. 2. Pull the handle straight out from the door. Make sure you keep the screws for reattaching handles. 3. To replace the handle, reverse the directions. Remove Door and Hinges IMPORTANT: Remove food and any adjustable door bins or utility bins from doors. WARNING Electrical Shock Hazard Disconnect power before removing doors. Failure to do so can result in death or electrical shock. 1. Unplug refrigerator or disconnect power. 2. Keep the refrigerator door closed until you are ready to lift it free from the cabinet. NOTE: Provide additional support for the refrigerator door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working. 6