KitchenAid KSF26C4XYW Use & Care Guide - Page 19

PROBLEM POSSIBLE CAUSES SOLUTIONS Temperature is too cold in the refrigerator/crisper The refrigerator air vent(s) are blocked If the air vent located in the top, left, rear corner of the refrigerator compartment is blocked by items placed directly in front of it, the refrigerator will get too cold. Move items away from the air vent. The controls are not set correctly for Adjust the controls a setting warmer. Check the temperature the surrounding conditions in 24 hours. See "Using the Controls." The ice storage bin is not in the correct See "Ice Maker." position Temperature is too cold in The control is not set correctly for the Adjust the control setting. See "Refrigerator Features." the pantry drawers items stored in drawer There is interior moisture buildup NOTE: Some moisture buildup is normal. The room is humid The door(s) are opened often or not closed completely The door is blocked open A humid environment contributes to moisture buildup. Allows humid air to enter the refrigerator. Minimize door openings and close doors completely. Move food packages away from door. A bin or shelf is in the way Push bin or shelf back into the correct position. Storing liquid in open containers This adds humidity to the refrigerator interior. Keep all containers tightly covered. There is frost/ice buildup in The doors are opened often or left the freezer compartment open Minimize door openings and keep doors fully closed. Poor door seal Ensure door seals are making full contact with the refrigerator cabinet to allow for an adequate seal. Temperature controls are not set correctly See "Using the Controls" for recommended temperature settings. PROBLEM The ice maker is not producing ice or is not producing enough ice Ice and Water POSSIBLE CAUSES SOLUTIONS The refrigerator is not connected to a water supply or the water supply shutoff valve is not turned on Connect refrigerator to water supply and turn water shutoff valve fully open. There is a kink in the water source line A kink in the line can reduce water flow. Straighten the water source line. The ice maker is not turned on Make sure the ice maker is on. See "Ice Maker." The refrigerator has just been installed Wait 24 hours after ice maker installation for ice production to begin. Wait 3 days for full ice production. The refrigerator door is not closed completely Close the door firmly. If it does not close completely, see "The doors will not close completely." A large amount of ice was recently removed Allow 24 hours for ice maker to produce more ice. An ice cube is jammed in the ice maker Remove ice from the ejector arm with a plastic utensil. ejector arm NOTE: On some models, press the lever which opens the ice maker door to access the ejector arm. A water filter is installed on the refrigerator Remove the water filter and operate the ice maker. If ice volume improves, then the filter may be clogged or incorrectly installed. Replace filter or reinstall it correctly. A reverse osmosis water filtration system is connected to your cold water supply This can decrease water pressure. See "Water Supply Requirements." 19