KitchenAid KSF26C4XYW Use & Care Guide - Page 21

PROBLEM POSSIBLE CAUSES SOLUTIONS Water is leaking or dripping from the dispenser system NOTE: A few drops of water after dispensing is normal. The glass was not held under the dispenser long enough Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever. Water continues to drip The refrigerator has just been installed Flushing the water system removes the air from the lines from the dispenser beyond which causes the water dispenser to drip. Flush the water the first few drops. system. See "Water Dispenser." The water filter was recently changed Flushing the water system removes the air from the lines which causes the water dispenser to drip. Flush the water system. See "Water Dispenser." Water is leaking from the back of the refrigerator The water line connections were not fully tightened See "Connect the Water Supply." Recently removed the doors and did See "Remove and Replace Refrigerator Doors and Drawer not fully tighten water line connection Front." Water from the dispenser is warm NOTE: Water from the dispenser is only chilled to 50°F (10°C). The refrigerator has just been installed Allow 24 hours after installation for the water supply to cool completely. A large amount of water was recently Allow 3 hours for the water supply to cool completely. dispensed Water has not been recently dispensed The first glass of water may not be cool. Discard the first glass of water dispensed. The refrigerator is not connected to a Make sure the refrigerator is connected to a cold water pipe. cold water pipe See "Water Supply Requirements." Doors WARNING Explosion Hazard Use nonflammable cleaner. Failure to do so can result in death, explosion, or fire. PROBLEM The door(s) or drawer will not close completely POSSIBLE CAUSES The door or drawer is blocked open The doors are difficult to open The doors appear to be uneven The doors do not open or close as expected A bin or shelf is in the way Recently installed The door gaskets are dirty or sticky The doors need to be aligned or the refrigerator needs to be leveled The refrigerator tilt needs to be adjusted SOLUTIONS Move food packages away from door(s). Remove ice or other items which have fallen onto the floor of the freezer compartment. Push bin or shelf back into the correct position. Remove all packaging materials. Clean gaskets and contact surfaces with mild soap and warm water. Rinse and dry with soft cloth. See "Door Closing and Door Alignment." Adjust the refrigerator tilt. See "Door Closing and Door Alignment." 21